Kohler Memoirs K-6880 Instrucciones De Instalación página 2

INSTALLATION
INSTALL THE LAVATORY
Rough-in the water supply lines and the drain with trap
according to the roughing-in information on Page 1.
Install sufficient backing material behind the finished wall
to provide support for the lavatory anchoring devices.
Use lag bolts to install the hanger to the wall according to
the roughing-in dimensions on Page 1.
CAUTION: Risk of personal injury or product
damage. Large lavatories are very heavy. Get help
lifting the lavatory into place.
Temporarily position the lavatory on the hanger, and
check for fit and placement. Make sure the lavatory is
level. Make adjustments as needed.
Mark the center of each anchoring hole on the finished
wall.
Carefully remove the lavatory from the hanger.
Use a 1/4" bit to drill each anchoring hole.
Temporarily thread the cap nuts to the threaded studs.
Use a wrench to install the threaded studs into the
anchoring holes so approximately 1-3/8" (3.5cm)
protrudes from the finished wall. Remove and save the
cap nuts.
Install the faucet and drain to the lavatory by following the
instructions packed with those products.
NOTE: Do not fully tighten the drain slip-joint connections
at this time.
CAUTION: Risk of product damage. Do not
overtighten the cap nuts. Overtightening may cause
damage to the lavatory.
Position the lavatory on the hanger so the threaded studs
extend through the lavatory mounting holes. Secure the
lavatory to the wall with the cap nuts and washers.
Connect the water supply lines to the faucet, and connect
the drain to the trap.
A
1007272-2-
Lag Bolt
Washer
Cap Nut
2
Hanger
Fig. #2
Hanger
Anchoring Hole
Fig. #3
Threaded
Stud
Fig. #4
Kohler Co., Kohler, WI, U.S.A.