Kohler Memoirs K-6880 Instrucciones De Instalación página 3

INSTALL THE LEGS
Refer to the measurements at right, and mark the leg
positions on the finished floor.
Use a 1/4" bit to drill each mark at least 1/2" (1.3cm) into
the finished floor.
Make sure the adjustable feet are fully retracted. Hand
turn them clockwise as needed.
NOTE: The leg assemblies are interchangeable.
Install the leg assemblies so the rubber bushings fit in the
holes on the underside of the lavatory. Hand turn the
adjustable feet counterclockwise until they fully engage
the drilled floor holes. The fit of each leg should be snug
but not forced.
NOTE: The lavatory is supported by both the legs and the
wall-mount hanger.
Check the lavatory and legs to ensure a level and plumb
fit. Adjust as needed.
Fit the wire rack on the leg assemblies.
If desired, apply a bead of sealant to the seam between
the lavatory and the finished wall. Follow the sealant
manufacturer's instructions.
CALL US FOR HELP
Here's what you need to do if you require service:
First review the installation instructions to ensure correct installation. For additional assistance in the USA, call our
Customer Service Department for direct help. You may also contact us at our web site listed below.
Kohler Co., Kohler, WI, U.S.A.
Call 1-800-4-KOHLER within the U.S.
Call 001-877-680-1310 within Mexico
Call 1-800-964-5590 within Canada
www.kohlerco.com
3
Finished Wall
1/4" Holes
23" (58.4cm)
Leg
Assembly
Wire Rack
2" (5cm)
15-1/2"
(39.4cm)
Fig. #5
Rubber
Bushing
Adjustable
Feet
Fig. #6
1007272-2-
A