Attach The Emergency Release Rope And Handle - LiftMaster 87504-267 Manual De Instrucciones

Abrepuertas de garaje led inteligentes
Ocultar thumbs Ver también para 87504-267:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation

6 Attach the Emergency Release Rope and Handle

To prevent possible SERIOUS INJURY or DEATH from a falling garage door:
If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED.
Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or
unexpectedly.
NEVER use emergency release handle unless garage doorway is clear of persons and obstructions.
NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.
1.
Insert one end of the emergency release rope through the handle. Make sure that "NOTICE" is right side
up. Secure with an overhand knot at least 1" (2.5 cm) from the end of the rope to prevent slipping.
2.
Insert the other end of the emergency release rope through the hole in the trolley release arm. Mount the
emergency release within reach, but at least 6 feet (1.83 m) above floor, avoiding contact with vehicles to
prevent accidental release and secure with an overhand knot.
NOTE: If it is necessary to cut the emergency release rope, seal the cut end with a match or lighter to prevent
unraveling. Ensure the emergency release rope and handle are above the top of all vehicles to avoid
entanglement.
Trolley
Release Arm
19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

845018780284602

Tabla de contenido