LiftMaster 87504-267 Manual De Instrucciones página 44

Abrepuertas de garaje led inteligentes
Ocultar thumbs Ver también para 87504-267:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting
DIAGNOSTIC CODE
Up Arrow Flash
Down Arrow Flash
(es)
(es)
4
1-4
4
5
4
6
The garage door opener will NOT enter Wi-Fi® learn mode:
After the initial installation of the garage door opener, the garage door opener must complete a full cycle
(open and closed) before the Wi-Fi® learn mode can be activated.
If there has been a recent power outage, the garage door opener must complete a full cycle before the
Wi-Fi® learn mode can be activated.
See 36 to activate Wi-Fi® learn mode.
Cannot connect garage door opener to home Wi-Fi® network:
Ensure the myQ® Serial number was entered correctly and try again. The myQ® characters are between A-
F and 0-9 only.
Weak Wi-Fi® signal in the garage. Ensure the Wi-Fi® signal is reaching the garage, see 4 or visit
support.chamberlaingroup.com for more information.
My door will not close and the lights blink on my opener:
The safety reversing sensor must be connected and aligned correctly before the garage door opener will move
in the down direction.
Check for binding or obstructions anywhere along the track to garage floor.
The safety reversing sensor must be connected and aligned correctly before the garage door opener will
move in the down direction.
Verify the safety reversing sensors are properly installed, aligned and free of any obstructions.
If the receiving sensor (green LED) faces direct sunlight, switch the receiving sensor with the sending
sensor so the receiving sensor is not in direct sunlight.
SYMPTOM
Door is moving, stops or reverses. Opener beeps and lights flash.
Opener runs approximately 6-8" (15-20 cm), stops and reverses.
The garage door opener will not close and the lights flash.
SOLUTION
Manually open and close the door. Check for binding or obstructions, such as a broken spring or door lock,
correct as needed. If the door is binding or sticking, contact a trained door systems technician. If door is not
binding or sticking attempt to reprogram travel (refer to 1).
Communication error to travel module. Check travel module connections, replace travel module if necessary.
Safety reversing sensors are misaligned or were momentarily obstructed. Realign both sensors to ensure both
LEDs are steady and not flickering. Make sure nothing is hanging or mounted on the door that would interrupt
the sensor's path while closing.
LEDs are not working:
Check wiring on both Integrated LED Light Modules to connector. If loose, then reconnect. If the lights do not
turn on, a new Integrated LED Light Module may be needed. Connect customer service or certified door
professional to determine if a new Integrated LED Light Module is needed.
My neighbor's remote control opens my garage door:
Erase the memory from your garage door opener and reprogram the remote control(s).
®
My vehicle's Homelink
is not programming to my garage door opener:
Depending on the make, model, and year of your vehicle an external adapter may be required. Visit
www.homelink.com for additional information.
My camera won't connect to the router:
Move your router closer to the garage door opener to minimize interference from walls and other objects.
Buy a Wi-Fi® range extender.
For issues with the camera, press and hold the reset button on the camera for 10 seconds. Then, follow the
®
myQ
app instructions to set up the camera.
To troubleshoot the optional automatic garage door lock model 841LM, see the instructions provided with
it.
44

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

845018780284602

Tabla de contenido