Installation In The Vehicle - Giordani pegasus plus Instrucciones

G P P
UK
IORDANI EGAsus Lus
KNOW YOUR CAR SEAT
1. This child seat must only be installed in
a forward facing position. This seat is
classified as:
- Group I for children weighing from 9kg
to 18kg (9 months - 4 years approx.)
- Group II for children weighing from
15kg to 25kg (3-6 years approx.)
- Group III for children weighing from
22kg to 36kg (5-12 years approx.)
usE IN THE VEHICLE
2. Your child car seat can only be installed
forward facing using a lap and diagonal
seat belt.
Do not use this child seat in passen-
ger seat equipped with airbags.
Not suitable for use on cars equipped
with inflatable belts.
Legal requirements: this child seat is
approved to ECE R44.04 and is ONLY
suitable for use with a 3 point and di-
agonal seat belt , approved to UN/ECE
Regulation No.16 or other equivalent
safety standards.
Important notes: in an emergency your
child can be released quickly by press-
ing the red button on the harness buck-
le. Keep this user guide in a safe place
where if can easily be found.
When the child seat is not in use it is
recommended that it is fastened into
the car with a seat belt to avoid being
thrown about in the event of an acci-
dent. If you travel with passengers us-
ing both the front and rear seats, the
lighter occupants should be in the rear
seats and the heavier occupants in the
front of the vehicle.
When a child is in the front seat, the
lighter passenger should be behind
1/2/3
CAR SEAT
(9 MONHS - 11 YEARS, APPROXIMATELY)
the child. Do not allow the child seat to
come into contact with corrosive sub-
stances e.g. battery acid.
sECuRING YOu BABY
3. Securing the harness
Place the right hand harness connector
behind the left hand one, they should
slot together neatly (3/ ). Push the har-
A
ness ends into the hole in the buckle
at the top of the crotch strap(3/
will hear and feel a 'CLICK' when it is
secure, check by attempting to remove
the connectors by pulling the webbing
above and below the buckle, periodi-
cally check that your child has not re-
leased the buckle (To release the har-
ness, press the red button down) (3/
4. Tightening and Loosening the
harness
Pull gently on the harness adjuster to
take up any slack (4/ ).
A
A loose harness is dangerous, so it
should be checked every time the seat
is used. It is recommended that there is
just enough room to insert two fingers
between the shoulder straps and the
child's chest (4/ ).
B
If the harness is too tight, loosen it by
first pressing the tab at the front of
the seat, and then pulling both straps,
as shown. Do not pull on the shoulder
pads, as these are fixed in length (4/
5. Adjusting the shoulder height
The harness has 3 height positions. The
straps should go into the slots nearest
to the top of your child's shoulders. If
your child's shoulders are between two
pairs of slots, always use the higher
position. Loosen the shoulder belts by
pressing the release button and pull-
20
ing the shoulder belts as far as you can.
Note! Do not
pull the belt pads (5/
To adjust the shoulder straps of the
harness, remove one of the shoulder
straps from the metal retaining yoke lo-
cated at the back of the seat. Leave the
other one in place for reference (5/
Pull the shoulder straps through the
harness slot in the shell and cover, then
pull through the shoulder pad (5/
Pull shoulder pad back through harness
slot in cover and shell, and re-locate to
). You
desired harness slot (5/
B
shoulder strap back through the shoul-
der pad, then through the same slot,
and re-attach to metal yoke at rear
(5/ ). Repeat the same procedure for
E
the shoulder strap and pad on the other
side, Make sure there are no kinks or
).
twists in the straps (5/
C
6. Adjusting the headrest height
The adjustable head support is de-
signed to provide side impact protec-
tion for your child (when the seat is
used with the backrest). To adjust the
height, unscrew the red locking device
located at the top back of shell. Move
up or down to the desired position, then
re-tighten the red locking device, mak-
ing sure that there is no movement in
the head support (6/
port should be positioned just above
your child's shoulders (6/
support can be removed to wash the
).
cover. Please see care & maintenance
C
section.
7. Adjusting the buckle position
You need to move the buckle to outer
position if the inner one is not fitting
your kid.
Before moving, please take out metal
clip of strap (7/ ); after moving, please
A
remember to put clip in (7/

INsTALLATION IN THE VEHICLE

8. Installation in vehicle for children up
).
A
to 13kg
Place the child's car seat on a passen-
ger seat with a 3 point seat belt. Make
sure the child seat is facing towards the
). front of the car. Pull the lap and diago-
B
nal sections of the car seat until fully
extended. Guide the seat belt around
). the side panel of the car seat making
C
sure that the lap belt is below the arm
rest of the seat base so that the pelvis
). Feed the is firmly engaged (8/
D
lap and diagonal belt into the side slot,
around the plastic back panel (over the
harness) and back through the oppo-
site slot (8/
seat and fasten in the normal way mak-
ing sure that the lap section is below
). the arm rest and the diagonal section
F
goes through the red guide (8/
sure that there are no kinks or twists in
the car seat belt. To check that seat is
fixed securely, tug the top of the shoul-
der straps there should be little or no
forwards movement (8/
tongue sections together and insert
them in the buckle with an audible
"click" (8/ ). Pull gently on the harness
E
adjuster to take up any slack (8/
). The head sup- 9. Installation in vehicle for children of
A
15-25kg
). The head Your child will be secured using the
B
vehicle's seat belt. It will therefore be
necessary to remove the harness fit-
ted to the child seat before use (9/
Please see Adjusting the shoulder
height 5/
A
strap by twisting and feeding the metal
retaining keeper through the bottom
of the child seat (9/
the seat's upholstery (9/
). head support by turning the red locking
B
21
). Then feed both
A
). Pull the belt around the
B
).Make
C
). Slide buckle
D
).
F
).
A
/5/ . Remove the crotch
B
). and up through
B
). Remove the
C