Docking Your Computer - Toshiba Express Port Replicator II Manual Del Usuario

20
Setting up and using the port replicator

Docking your computer

Connecting a LAN cable
NOTE
To connect a LAN cable to the port replicator, follow the steps
below:
1 Plug one end of the network cable into the port replicator's
network port. Gently push the cable connector in until you hear
the latch click into place.
(Sample Illustration) Connecting a LAN cable to the network port
2 Plug the other end of the cable into a LAN hub connector.
Docking your computer
The system supports hot docking and undocking.
1 Align the slots on the front of the computer with the front
hooks on the port replicator. Seat the computer so that the
hooks engage the slots.
The computer may need to be configured before connecting to a
LAN. Check with your LAN administrator regarding set up
procedures.