Mounting The Guard For Cutting; Removing The Guard For Cutting; Removing The Guard For Grinding - Parkside PWSAP 20-Li C3 Manual De Instrucciones

˜ Mounting the guard for
cutting
NOTE
For cut-off grinding, you must fit the guard
u
for cutting to the guard for grinding
[ ]
m
WARNING!
Before mounting or removing the guard
for cutting
[
Remove the battery pack
the product to prevent the product
from starting unintentionally. Let the
product cool down before mounting or

removing the guard for cutting!

Switch the product off. Remove the battery
pack from the product to prevent the
[ 5 ]
product from starting unintentionally.
Remove the grinding/cutting disc, if
applicable (see "Attaching/removing the
accessory tool").
Align the teeth on the edge of the guard for
cutting with the guard for grinding
[ ]
Turn the guard for cutting
you can feel the lock on the guard for cutting
clicking into place (Fig. I).
Check if the guard for cutting
seated.
52 GB/IE
[
: Switch the product off.
]
from
5 ] [
.
[ ]
clockwise until
[ ]
is firmly
[ ]
˜ Removing the guard for
cutting
Switch the product off. Remove the battery
pack from the product to prevent the
[ 5 ]
product from starting unintentionally.
.
]
Remove the grinding/cutting disc, if
applicable (see "Attaching/removing the
accessory tool").
Press the lock on the guard for cutting
outwards. Turn the guard for cutting counter-
clockwise (Fig. I).
˜ Removing the guard for
grinding
m
WARNING!
Before mounting or removing the guard
for grinding
off. Remove the battery pack
the product to prevent the product
from starting unintentionally. Let the
product cool down before mounting or

removing the guard for grinding!

Switch the product off.
Remove the battery pack
product to prevent the product from starting
unintentionally.
Remove the grinding/cutting disc (see
"Attaching/removing the accessory tool").
Remove the backing flange
Remove the retaining ring
of the aluminium head.
[
: Switch the product
[ ]
from
5 ] [
from the
5 ] [
.
[ ]
from the groove
[ ]
]