Switching On And Off - Parkside PWSAP 20-Li C3 Manual De Instrucciones

m
CAUTION! RISK OF INJURY!
Only use accessory tools recommended by
u
the manufacturer. Using other accessory
tools and other accessories can represent a
risk of injury for you.
Only use accessory tools, which bear
u
information about the manufacturer, type of
binding, dimension and permitted number
of revolutions.
Only use accessory tools where the printed
u
rotational speed is at least as high as what
has been specified on the product marking.
Do not use any broken, cracked, or
u
otherwise damaged accessories.
Only use flawless accessory tools.
u
Ensure that the accessory tool dimensions
u
match those of the product.
Never re-drill a locating hole which is too
u
small to make it larger.
Never use separate bushings or adaptors
u
in order to make discs with a hole that is
too large fit the product.
Support plates or workpieces to reduce the
u
risk of kickback from a jammed disc. Large
workpieces may bend under their own
weight. The workpiece must be supported
on both sides of the disc, near the disc as
well as at the edge.
54 GB/IE
Release the locking flange
the spindle lock button
the tightening tab in a counter-clockwise
direction. Release the spindle lock button
(Fig. G).
Remove the locking flange
If applicable, remove the current accessory
tool.
Mount the desired accessory tool onto the
backing flange
[
Press and hold the spindle lock button
Lift up the tightening tab. Thread the locking
flange in a clockwise direction. Use
[ ]
the tightening tab to tighten the accessory
tool securely. Push down the tightening tab.
Release the spindle lock button.
˜ Switching on and off
m
CAUTION! RISK OF INJURY!
Always wear protective gloves when
handling or working with the product.
K
: Press and hold
[ ]
. Lift up and rotate
1 ] [
.
[ ]
(Fig. H).
]
1 ] [
.