Bosch CCS180 Instrucciones De Funcionamiento Y Seguridad página 14

2610046822.qxp_CCS180 3/23/17 1:20 PM Page 14
RIP CUTS
The combination blade provided with your saw
is for both cross cuts and rip cuts. Ripping is
cutting lengthwise with the grain of the wood.
Narrow rip cuts are easy to do with a rip fence
(Fig. 13). To attach fence, insert fence
through slots in foot to desired width as shown
and secure with the knob.
be sure the rip fence does not touch or
interfere with the free movement of the
lower guard or contact the saw blade.
RIP BOARD GUIDE
When rip cutting large sheets, the rip fence
may not allow the desired width of cut. Clamp
or nail a straight piece of 1" (25 mm) lumber to
the sheet as a guide (Fig. 14). Use the right
side of the foot against the board guide.
charger Operating Instructions included with
your tool. Using other types of batteries may
result in personal injury or property damage.
Slide charged battery pack into the housing
until the battery pack locks into position
(Fig. 1).
Your tool is equipped with a secondary locking
latch to prevent the battery pack from
completely falling out of the handle, should it
become loose due to vibration.
After attaching
adjusting the rip fence,
INSERTING AND RELEASING BATTERY PACK
Use only Bosch batteries
recommended in the
FIG. 13
or
KNOB
RIP
FENCE
FIG. 14
RIP
BOARD
GUIDE
To remove the battery pack, press the battery
pack release button and slide the battery pack
forward.
Press the battery pack release button again
and slide the battery pack completely out of
tool housing (Fig. 1).
-14-
DESIRED
WIDTH
OF CUT
DESIRED
LINE
OF CUT