Attaching The Blade - Bosch CCS180 Instrucciones De Funcionamiento Y Seguridad

2610046822.qxp_CCS180 3/23/17 1:20 PM Page 10

ATTACHING THE BLADE

any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
greater. Using blade not designed for the saw
may result in serious personal injury and
property damage.
1. Turn BLADE STUD with wrench provided
clockwise and remove BLADE STUD and
OUTER WASHER (Fig. 2). If the shaft
moves while attempting to loosen the blade
stud press the lock button (Fig. 1).
2. Make sure the saw teeth and arrow on the
blade point in the same direction as the
arrow on the lower guard.
3. Retract the lower guard all the way up into
the upper guard. While retracting the lower
guard, check operation and condition of the
LOWER GUARD SPRING.
4. Slide blade through slot in the foot and
mount it against the INNER WASHER on
the shaft. Be sure the large diameter of the
OUTER washer lays flush against the blade.
UPPER
GUARD
LOWER GUARD
BLADE SHAFT
LOWER GUARD SPRING
INNER WASHER
Large Diameter Faces Blade
Assembly
Disconnect battery pack
from tool before making
Use only 6-1/2" blade
rated 3900/min (RPM) or
5. Reinstall OUTER WASHER and tighten
BLADE STUD finger tight. The face of upper
guard has marks around it that will help you
properly adjust the blade stud. Press lock
button to lock shaft and TIGHTEN BLADE
STUD COUNTER-CLOCKWISE TWO
MARKS ON UPPER GUARD WITH THE
WRENCH PROVIDED.
Do not use wrenches with longer handles,
since it may lead to over tightening of the
blade stud.
VARI-TORQUE CLUTCH
This clutching action is provided by the friction
of the OUTER WASHER against the BLADE
and permits the blade shaft to turn when the
blade encounters excessive resistance. When
the BLADE STUD is properly tightened (as
described in No. 5 of Attaching The Blade), the
blade will slip when it encounters ex cessive
resistance, thus reducing saw's tendency to
KICKBACK.
One setting may not be sufficient for cutting all
materials. If ex cessive blade slippage occurs,
tighten the blade stud one mark more.
OVERTIGHTENING THE BLADE STUD
NULLIFIES THE EFFECTIVE-NESS OF THE
CLUTCH.
FIG. 2
WRENCH
BLADE
-10-
MARK
OUTER
WASHER
OUTER WASHER
Large Diameter
Faces Blade
BLADE STUD
TIGHTEN
LOOSEN