Bosch CCS180 Instrucciones De Funcionamiento Y Seguridad página 15

2610046822.qxp_CCS180 3/23/17 1:20 PM Page 15
Preventive maintenance performed by un -
au thorized personnel may result in
misplacing of
components which could cause serious
hazard. We recom mend that all tool service
be performed by a Bosch Factory Service
Center or Authorized Bosch Service Station.
SERVICE MEN: Disconnect tool and/or
charger from power source before servicing.
BATTERIES
Be alert for battery packs that are nearing
their end of life. If you notice decreased tool
performance or significantly shorter running
time between charges then it is time to
replace the battery pack. Failure to do so can
cause the tool to operate improperly or
damage the charger.
TOOL LUBRICATION
Your Bosch tool has been properly lubricated
and is ready for use.
D.C. MOTORS
The motor in your tool has been engineered
for many hours of dependable service. To
maintain peak efficiency of the motor, we
(*= standard equipment)
(**= optional accessories)
* rip fence
Maintenance
Service
NO USER SERVICE -
ABLE PARTS INSIDE.
internal wires
Accessories
The use of any other acces so ries not specified in this manual may create a hazard.
recommend it be examined every six
months. Only a genuine Bosch replacement
motor specially designed for your tool should
be used.
and
Bearings which become noisy (due to heavy
load or very abrasive material cutting) should
be replaced at once to avoid overheating and
motor failure.
tool and/or charger from the power supply
before cleaning. The tool may be cleaned
most effectively with com pressed dry air.
Always wear safety goggles when cleaning
tools with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through opening.
plastic parts. Some of these are: gasoline,
car bon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
* 6-1/2" thin kerf 18 tooth carbide blade
** 6-1/2" thin kerf 24 tooth carbide blade
-15-
BEARINGS
Cleaning
To avoid accidents,
always disconnect the
Certain cleaning agents
and solvents damage