Side View - LUND Rampage Products 86623 Instrucciones De Instalación

Installation Instructions
5
Adjust the latch as needed to achieve the fit shown in the
illustrations below (A). Use the included Allen wrench to
tighten the set screws.
A

Side View

6
Adjust of latch and handle
Set Screw
Latch
Now install the leg assemblies to the roll bar clamps
with the small hex nut/lock washer/flat washer as
shown. Once installed tighten the factory rear seat nuts.
NOTE: Use the clamps to adjust the height of both
legs assemblies so the rack sits flat on both padded
platforms of the leg assemblies. Tighten the clamps.
If the handle assembly loosens up, use the
included Allen wrench to adjust and tighten the set
screws on the collars securing the latch rods as
shown in the illustration below (B).
B
Set Screw
4
Handle