User Maintenance - Olivetti d-Copia 12 Manual De Instrucciones

3. Remove the toner cartridge from the bag. Grasp the
cartridge on both sides and shake it horizontally four
or five times. After shaking the cartridge, remove the
toner seal.
4 or 5 times 4 or 5 times
Shutter Shutter
Grasp the toner cartridge as shown in the
illustrations. Do not hold the cartridge by the
shutter. Be sure to only shake the cartridge
before the toner seal is removed.
4. Gently insert the toner cartridge along the guides until
it locks in place while pushing the lock release lever.
Remove the tape from the shutter. Pull the shutter out
of the toner cartridge as shown in the illustration.
Discard the shutter.
5. Close the front cover and then the side cover by
pressing the round projections near the side cover
s
open button. The indicator will go out and the ready
( ) indicator will light up.
When closing the covers, be sure to close
the front cover securely and then close
the side cover. If the covers are closed in
the wrong order, the covers may be da-
maged.
Even after a new cartridge is installed,
the ready ( ) indicator may not light up,
indicating copying can not be restarted
(toner is not sufficiently fed). In this case,
open and close the side cover. The copier
will feed toner again approximately 2 mi-
nutes and then copying can be restarted.
All manuals and user guides at all-guides.com
Toner seal
Toner seal

USER MAINTENANCE

Proper care is essential in order to get clean, sharp
copies. Be sure to take a few minutes to regularly clean
the copier.
• Before cleaning, be sure to turn the power
switch off and remove the power cord from
the outlet.
• Do not use thinner, benzene or other volatile
cleaning agents.
Cabinet
Wipe the cabinet with a soft, clean cloth.
Original table and original cover
Stains on the glass cover will also be copied. Wipe the
glass cover with a soft, clean cloth. If necessary, dampen
the cloth with a glass cleaner.
Transfer charger
If copies start becoming streaky or blotchy, the transfer
charger may be dirty. Clean the charger using the follow-
ing procedure:
1. Turn the power switch off.
2. Open the side cover whilst pressing the side cover
open button.
3. Take the charger cleaner out by holding the tab.
GB-13