STATUS INDICATORS
Be sure to use only original spare parts and
supplies.
Indication
Developer
q
replacement required
indicator
s
Toner cartridge
replacement
required indicator
Misfeed indicator
t
Maintenance indicator
n
"CH" is steadily lit in the
display
Q
"P" is blinking in the
display
A letter and a number
appear alternately.
DISPLAYING TOTAL NUMBER OF
COPIES
Use the following procedure to display the total number of
copies:
>
1. Press the clear (
) key to reset the display to zero.
2. Press and hold down the clear (
tely 5 seconds. The total number of copies will appear
in two steps, each with three digits.
Example:
Total number of copies is 1,234
All manuals and user guides at all-guides.com
Cause and remedy
Steadily lit
Developer is required. Contact your service centre as soon as
possible.
Replacement of toner cartridge will be needed soon. Obtain a
Steadily lit
new cartridge. p. GB-12
Blinking
Toner cartridge must be replaced. Replace it with a new one. p. GB-12
Blinking
A misfeed has occurred. Remove the misfed paper referring to the
description of „Misfeed removal." p. GB-14. Lever of fusing area
is not raised. p. GB-15. The lower side cover may be open.
If so, close it.
Steadily lit
Service by an authorized service technician is required.
p. GB-16
Side cover is open. Close the side cover securely by pressing
the round projections near the side cover open button. p. GB-13
Paper tray is empty. Load copy paper. p. GB-6
A misfeed has occurred in the paper tray. Remove the misfed paper.
p. GB-15
Paper tray is not securely installed. Push the tray in securely.
p. GB-6
The copier will not function. Turn the power switch off and then
switch it on,and if there is again an error, remove the power cord
from the outlet, and contact your authorized service center.
>
) key for approxima-
When the following indicators light up or blink on the
operation panel or the following symbols appear in the
display, solve the problem immediately referring to both
the table below and the relevant page.
GB-17