Developer Required; Maintenance Required; Copier Trouble - Olivetti d-Copia 12 Manual De Instrucciones

DEVELOPER REQUIRED

When the q indicator lights up, the developer should be
replaced. DEVELOPER REPLACEMENT SHOULD
ONLY BE DONE BY AN AUTHORIZED SERVICE TECH-
NICIAN. Contact your service centre as soon as
possible.

COPIER TROUBLE

If any problem occurs, check the list below before contacting the Service Center.
Problem
Copier plugged into a power outlet?
Copier does not ope-
rate.
Power switch on?
Side cover closed securely?
Front cover closed?
Is the original placed face down on the
Blank copies
original table?
Is the copier in the preheat mode?
Power save ( )
indicator on.
Is the copier in the auto power shut-off
mode?
Is the original image too dark or too
Copies are too dark or
light?
too light.
Is the copier in the automatic exposure
mode?
Is the copier in the photo exposure
mode?
Original table or original cover dirty?
Dust, dirt, smudges
appear on copies.
Original smudged or blotchy?
Is the transfer charger clean?
Striped copies
Non-standard paper used?
Paper misfeeds fre-
quently.
Paper curled or damp?
Pieces of paper inside copier?
Paper guides in the paper tray not set
properly.
Too much paper in the paper tray or badly
placed in the cassette?
Is the copy paper too heavy?
Images rub off the
copy easily.
Paper damp?
GB-16
All manuals and user guides at all-guides.com
Possible cause

MAINTENANCE REQUIRED

p
When the indicator lights up, service by an authorized
service technician is required. Contact your service cent-
er as soon as possible.
Solution
Plug the copier into a grounded outlet.
Turn the power switch on.
Gently close the side cover. p. GB-13
Gently close the front cover and then close
the side cover. p. GB-13
Place the original face down on the original
table. p. GB-7
Press any key to cancel the preheat mode.
p. GB-11
Press the print ( ) key to cancel the auto
power shut-off mode.
Adjust the exposure manually.
Adjust the automatic exposure level.
p. GB-8
Cancel the photo exposure mode.
p. GB-8
Clean regularly. p. GB-13
Use a clean original.
Clean the transfer charger.
Use standard paper. If using special papers,
feed the paper through the manual bypass.
p. GB-10
Store copy paper flat in the wrapper in a dry
location. p. GB-7
Remove all pieces of misfed paper.
p. GB-14
Set the guides properly depending on the
paper size. p. GB-6
Remove excessive paper from the paper tray
or follow advice. p. GB-7
Use copy paper within the specified range.
p. GB-7
Replace with dry copy paper. If the copier is
not used for a long time, remove the paper
from the paper tray and store it in its wrapper
in a dry location. p. GB-7
p. GB-4
p. GB-11
p. GB-8
p. GB-13