Cabinet Installation - Electrolux ECWM3011AS Instalación

Ocultar thumbs Ver también para ECWM3011AS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MICROWAVE/WALL OVEN COMBINATION INSTALLATION

3. Cabinet Installation

IMPORTANT!
Do not lift or manipulate the oven by the door handle
or the control panel.
Heavy Weight Hazard
• Use 2 or more people to move and install wall oven.
• Failure to follow this instruction can result in injury or
damage to the unit.
1. Unpack the wall oven. Remove the bottom trim
taped on the oven side panel.
2. Find the 2 anti-tip mounting screws included in the
oven cavity.
3. Insert the oven into the cabinet opening. Slide oven
inward leaving 1½" (3.8 cm) clearance between the
oven and front of cabinet (see Figure 6).
4. Pull the armored cable through the hole for it in the
cabinet and toward the junction box while moving
the appliance inward.
5. Push the oven in and against the cabinet.
Figure 6: Cabinet Installation
1½" (3.8 cm)
clearance
between unit
6
1. Install the Anti-tip Mounting Screws
The wall oven can tip when the door is
open. The anti-tip mounting screws supplied with the
wall oven must be installed to prevent tipping of the
wall oven and injury to persons.
A. The mounting holes in the side trims may be
used as a template to locate the appliance mounting
screw holes (see Figure 7).
B. Use the two screws supplied to fix the appliance
to the cabinet.
Figure 7: Anti-tip screw locations
Tip Over Hazard
• A child or adult can tip the oven
and be killed.
• Install the anti-tip device to oven
and/or structure per installation
instructions.
• Ensure the anti-tip device is re-engaged when the
oven is moved.
• Do not operate the oven without the anti-tip device
in place and engaged.
• Failure to follow these instructions can result in
death or serious burns to children and adults.
Anti-tip mounting holes
Refer to the installation
instructions supplied with your
appliance for proper installa-
tion.
Check for proper installation
with a visual check that the
anti-tip screws are present.
Test the installation with light
downward pressure on the
open oven door. The oven
should not tip forward.

Publicidad

Tabla de contenido
loading

Tabla de contenido