Error Codes - BH G6755 Manual Del Usuario

ERROR CODES

E01-E13 Possible cable fault
E02 Low voltage
E03 No speed sensor signal
E04 Incline motor failure
E05 Possible motor overload
E06-E10 Motor failure
E08 Burned control board
Do not hesitate to get touch with the Technical Assistance Service if you have any
queries by phoning customer services (see last page in manual).
Connect the wire between top controller and
console.
a.- Check motor wires.
b.- Check that the control board is not burned
(strong smell or smoke).
c.- Check that the voltage is correct.
Check the position or replace the speed
sensor.
Check the incline motor and sensor wires.
Replace the incline motor if necessary.
a.- Lubricate the belt.
b.- Check that the motor is not burned.
c.- Check that the control board is not burned.
Check the motor wires. Replace the motor if
necessary.
Change the control board.
12