Peavey PVX pSub Manual Del Usuario página 23

ON-OFF SWITCH (3)
This rocker switch supplies AC power to the PVX
with the left side of the switch pushed "in" or nearly flush with the rear panel.
REAR PANEL TOP
ACCESS PANEL FOR OPTIONAL EXPANSION MODULE
This panel is to be removed ONLY when installing one of a variety of Optional Expansion Modules that will be
available soon for the PVXp Sub.
These Optional Expansion Modules will either work in conjunction with the input already present on the PVXp
Sub, or provide an in-line function for the input, such as a 10-band EQ, etc. Check with your Peavey
availability and price.
If you are not installing such an Optional Expansion Module, then do not remove this cover, instructions for
installing an Optional Expansion Module will come with each Expansion Module and will be specific for that
Module.
5
6
7
4
8
TOP – OPERATING CONTROLS, INPUTS & OUTPUTS
INPUT (4)
The line-level input is of the medium impedance balanced type. The jack is a combo female XLR and 1/4" TRS
connector.
LED (5)
Illuminates GREEN when the power switch is on and power is present
It turns RED when the power amp engages the DDT
but not a constant illumination, or distortion will be excessive.
There is also an LED visible on the front baffle of the Sub that illuminates BLUE when power is applied, and
turns RED when the power amp engages the DDT "soft limiting" circuitry.
LEVEL (6)
Controls the gain or output level of the input signal. It is used to directly set the system output level for a given
input signal.
Normal usage is with the knob set to half-way, this is then equivalent in gain to a typical power amp input.
p Sub when switched to the ON position. The ON position is
™
™ "soft limiting" circuitry. Occasional flashing is acceptable,
® dealer for
9
11-12
13
10