Protection Equipment; Fuels/Refueling; Starting - stayer OLMO G1-250 Manual De Instrucciones

shall however be allowed to use the chain saw for the
purpose of training provided they are under the
supervision of a qualified instructor.
- Always use the chain saws with maximum care and
attention.
- Only use the chain saw when you are in good conditions.
If you are tired, your attention will decrease. Take special
care at the end of a working day. Carry out any work
calmly and carefully. The user shall have to accept
responsibility towards third persons.
- Never work under the influence of alcohol, drugs or
medicaments.
- When working in an easily inflammable vegetation or
when it should not have rained for a prolonged period of
time (forest fire hazard), a fire extinguisher must be
available nearby.
3.2 Protection equipment (Figs. 3 and 4)
To avoid injuries at your head, eyes, hands or feet as
well as to protect your ears, you must use the following
protection equipment when working with the chain
saw:
- The kind of clothing must be suitable, i.e. it must be tight-
fitting without being uncomfortable. Do not wear gems or
clothing that may get tangled up in bushes or shrubs. If
you wear long hair, always use a hair net!
- It is always necessary to wear a safety hard hat when
working with the chain saw. The hard hat (A) must be
checked at regular intervals to see if it is damaged, and
replaced by a new one after a maximum of 5 years. Use
only homologated safety hard hats.
- Face shield (B) of the safety hard hat (or safety goggles)
protects you from sawdust and splinters. During the use
of the chain saw, always use safety goggles or a face
shield to avoid suffering eye injuries.
- Use noise protection equipment (C) (earmuffs, ear
protectors, etc.).
- The safety jacket (D) consists of 22 nylon layers and
protects the operator from cuts. It must always be used
when one works from lifted platforms (platforms for
collecting fruit, elevators), from platforms mounted on
ladders or when climbing with ropes.
- The safety dungarees (E) are made of 22-layer nylon
fiber and protect against cuts. Use thereof is earnestly
recommended.
- The protective gloves (F) made of thick leather are part
of the required equipment and shall be used when using
the chain saw.
- When using the chain saw, safety shoes or safety boots
(G) with nonslip sole, steel toecap and leg protector shall
always be used. Safety shoes with a protective layer offer
protection against cuts and ensure good stability. For
working in trees, the safety boots shall have to be suitable
for climbing techniques.

3.3 Fuels/Refueling

- Stop the engine before refueling the chain saw.
- Do not smoke or work near fires (Fig. 5).
- Let the engine cool down before refueling.
- Fuels may contain substances similar to solvents. Eyes
and the skin shall not enter into contact with mineral oil
products. Always use protective gloves when refueling.
Wash and replace the protection clothing frequently. Do
not inhale fuel vapors.
- Do not splash fuel or chainsaw oil, clean the chain saw
immediately. Fuel must not enter into contact with
ENGLISH
All manuals and user guides at all-guides.com
39
- Make sure that fuel or chainsaw oil is not allowed to filter
- Refueling in closed rooms is not permitted. Fuel vapors
- Make sure to tighten the threaded lids of the fuel and oil
- Move to another place before starting the motor (at least 3
- Fuel may not be stored for an unlimited period of time.
- Use only recipients that a homologated and marked for
- Check the cabling device for perfect performance of the

3.4 Starting

- Do not work unaccompanied. Someone must be near
- Make sure that there are no children or other people in the
- Before starting to work, you must check the chain
- Especially check the operation of the brake of the chain,
- Start the chain saw only if it is completely assembled.
- Before starting the chain saw, make sure that the soil on
- Only start the chain saw in the way described in this
- When you start the chain saw, it must be well-supported
- Always hold the chain saw with both hands when
- Continuously check that the soil on which you are
- Hold the chain saw in such a manner that you do no inhale
- Stop the chain saw immediately when you notice a
39
clothing. If your clothing enters into contact with fuel,
immediately change clothes.
into the soil (protection of the environment). Use a
suitable base.
accumulate near the floor (explosion hazard).
tanks.
m away from the place of refueling) (Fig. 6).
Acquire only the quantity you will consume in a near
future.
the transport of fuel and chainsaw oil. Make sure that
children cannot access the fuel or chainsaw oil.
machine (OLMO22-400)
for a possible case of emergency.
working area. Pay attention also to any animal that may
be present in the working area (Fig. 7).
saw to make sure that it operates perfectly and safely
in accordance with the indications.
the correct assembly of the guide bar, correct sharpening
and tightening of the chain, the firm assembly of the
pinion guard, easy movement of the accelerator lever and
locking operation of the accelerator lever, the cleanliness
and dryness of the handles and the operation of the
ON/OFF switch.
Never use the chain saw if it is not completely assembled.
which you are standing is stable.
instruction manual (Fig. 8). No other starting methods are
allowed.
and held firmly. Neither the guide bar nor the chain must
be on contact with any object.
working with it. Catch the rear handle with your right
hand and the tubular handle with your left hand. Grasp
the handles firmly with your thumb orientated towards
your fingers. It is extremely dangerous to work with one
hand only, because the chain saw may drop without
control through the completed cut (high hazard of injury).
Further, with one hand only it is impossible to control that
it recoils.
When releasing the accelerator lever, the
chain may still rotate for a short period of time
(rotation due to inertia).
stepping is stable.
exhaust gases. Do not work in closed rooms (hazard of
intoxication).
change in its operation.