Intended Use; Safety Advice - BGS technic 9493 Manual De Instrucciones

VAG 1.2 / 1.4 TSi / TFSi (ACT / COD)
TOOLS
1. Camshaft Positioning Tool,
to be used as OEM T10504
2. Camshaft Timing Pin,
to be used as OEM T10504/1
3. Camshaft Timing Check Pin,
to be used as OEM T10504/2

INTENDED USE

This tool set is designed for setting the camshaft when checking or adjusting the valve timing on 1.4 TSi /
TFSi engines with engine code CPTA, CZEA and active cylinder management ACT or COD. This engines
are built in e.g. Audi A1 (2013-), A3 (2013-), Q3 (2014-) - VW Passat (2012), Golf (2012-), Polo (2015-) -
Seat Leon (2014-), Ibiza (2013-) - Skoda Superb (2015-)

SAFETY ADVICE

•
Do not use the set if any parts are missing or damaged.
•
Only use this tool for the purpose for which it is intended.
•
Never lay tools on the vehicle's battery. This may short the terminals together.
•
Be careful when working on running engines. Loose clothes, tools and other things can be caught up
in revolving parts which may lead to serious injuries.
•
Keep children and other unauthorised persons away from the working area.
•
Be careful when working on hot engines – risk of burn!
•
Remove the negative battery connection before repairing, so you avoid short circuits and that the
engine will not start unintentionally.
•
This manual is just brief information and will not replace a garage handbook.
•
Always consult specific service literature for information about torques, assemblies and
disassemblies etc.
•
After any successful maintenance and before starting the engine, you should rotate the engine for
two turns manually to check the new control time.
•
Turn the crankshaft in the normal direction (clockwise unless stated otherwise) and only at the
crankshaft itself, never turn the crankshaft by turning camshaft or another wheel.
ATTENTION
Do not use setting tools as a counterholder tool when loosening or tightening the
camshafts, crankshafts or balance shaft wheels. Use only a holding tool for this
purpose, otherwise setting tools or engine components may be damaged.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
1
Camshaft Timing Tool Set for
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 9493
1
3
2
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed