Publicidad
Idiomas disponibles
Idiomas disponibles
-Solvent based lubricants used,
- Belt is too tight.
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there, Fig.0:
(A) Main structure; (B) Console base;
(C) Console; (A03) Left upright tube;
(A04) Right upright tube; (C07) Lower
cover; (C17) Left upright tube cover;
(C18) Right upright tube cover; (D09)
Safety key; (D13) MP3 wire; (D27)
Power wire;
(E01)
Screw
M10x45; (E15) Bolt M8x25; (E16) Bolt
M8x15; (E28) Washer D8; Wrenches.
Follow the instructions step by step to
assemble:
1 Take the unit out of the box and
place it on the floor as shown in Fig.1.
Please do not cut packing belt (I)
before you finish assembly.
2 Take the right upright tube (A04)
connect terminals (D05) (D06) Fig.2,
then insert the tube into the bottom
right-hand support on the structure
and use screws (E07).
Now take the left upright tube (A03)
Fig.B
ST4,2x8;
(E07)
and insert it into the bottom left-hand
support on the structure and use
screws (E07) to secure it.
3 Position the lower left cover (C17)
and
right
corresponding tube as shown in Fig.3
and push them down.
4 Take the console base (B) and
connect the terminals (D04) (D05),
Fig.4.
Place the base (B) on the upright
tubes and fit the screws (E16) and the
washers (E28).
5 Take the console (C) and connect
the terminals that come out of the
monitor with the terminals of the same
color that come out of the base (B),
Fig.5.
6 Attach the console (C) using the
screws (E15), Fig.6.
7 Attach the lower cover (C07) using
the screws (E01), Fig.7.
Bolt
8. Remove the packing belt (I), Fig.8.
Loosen the screw (E16) on the lower
frame, Fig.8. Fold the unit following the
instructions below and loosen the
screw (E16) under the board, Fig.8, I.
Remove the safety block (B11).
9. Insert the safety key, Fig.9.
10 LUBRICATION.-
CAUTION: Before the first use,
apply approximately half the bottle
of lubricant in the central part and
along the entire board, and on both
sides as shown in Fig.10.
(due to different running styles, always
apply more lubrication to the area where
19
cover
(C18)
on
the
Publicidad
