Fault Finding Chart - BH HRT-05 Instrucciones De Montaje Y Utilización

FAULT FINDING CHART

PROBLEM
The monitor does not
switch on.
The monitor switches on
but the motor fails to
start.
Walking motion is jerky
on the treadmill.
The machine stops (the
breaker trips).
Electrical shocks through
the handrail.
The treadmill belt skews
off centre.
CHECKS
1) Make sure that the
machine is plugged in,
the ON/OFF switch in
position 1 and that the
safety key is inserted.
2) Check that the current
limiter is pressed in.
3.a) Check that the belt is
lubricated.
3.b) Check the tension on
the sliding belt.
3.c) Check the tension on
the drive belt.
4) Check that the band is
lubricated.
5) Check that
machine is plugged into
an earthed mains socket.
6.a) Check
machine is level on the
floor.
6.b) Check
machine does
wobble.
24
SOLUTIONS
1) Plug the machine into
the mains supply. Set the
switch to position 1 and
insert the safety key.
2) Switch the machine off
and
breaker in. Lubricate the
treadmill band.
3.a) Lubricate the sliding
belt.
3.b)
tension.
3.c) Adjust the drive belt
tension.
4) Reset the overload
button with the On /Off
switch at „0" and lubricate
the treadmill band.
the 5) Plug the machine into
an earthed mains socket.
that the
that the
not
press the circuit
Adjust the belt