Kohler K-6330 Instrucciones De Montaje página 7

Valve Outlet
Gasket
Channel
Spray
Hose
6. Handspray Installation
Cover the sprayhead with clean packing wrap to protect it from
damage during installation.
Insert the spray hose into the spout.
Fit the gasket into the valve outlet.
Hold the valve outlet in place with a wrench.
Thread the spray hose to the valve outlet. Hand tighten only.
Remove the packing wrap from the sprayhead.
Open the valve. Water will flow from the sprayhead.
Check for leaks. Adjust as needed.
Test the water flow of the spray control. Water flow will increase
when the handle is pushed lightly inward. Water flow will stop
when the handle is pushed fully inward.
Close the valve.
Kohler Co.
Spout
Sprayhead
7 1025493-2-B