Sony HT-BE1 Manual De Instrucciones página 13

Specifying the speaker parameters
For the best possible surround sound, specify the distance of the speakers from your listening
position.
This system will reproduce the best possible surround sound by automatically adjusting the
output from each speaker according to the speaker's position.
Details of each parameter will follow the description of the operation.
SHIFT
1
Press ?/1 (POWER) to turn on the system.
2
While pressing SHIFT, press SOUND FIELD.
DSG is displayed on the diplay window of the subwoofer.
3
While pressing SHIFT, press VOLUME +/–.
Each time you press VOLUME +/–, the speaker is selected and displayed in the following
order. After the speaker of which parameter you want to specify appears, press SOUND
FIELD while pressing SHIFT again.
DSG (Dynamic Sound Generator) (page 20) T
r
DRC (Dolby Dynamic Range Control) (page 19)
r
AUTO (page 23)
r
F-DST (FRONT DISTANCE) (page 14)
r
C-DST (CENTER DISTANCE) (page 14)
r
R-DST (REAR DISTANCE) (page 14)
4
While pressing SHIFT, set the parameter using VOLUME +/–.
5
Repeat Steps 2 to 4 to set other parameters.
If you do not operate the remote for a few seconds, the parameter turns off and is stored in
the system.
?/1 (POWER)
SOUND FIELD
VOLUME +/–
continued
GB
13