Hach 9525sc Degas System Manual Del Usuario página 13

Complete the steps that follow to connect the sample line. Refer to
1. Use a 1/4-inch NPT connection to connect the sample line to the sample inlet.
2. Use a 1/4-inch NPT connection to connect the sample outlet line to the sample outlet. The outlet
must drain into a floor drain.
3. Unroll the condensate drain tube.
4. Push the condensate drain tube through the hole in the rear of the unit. Make sure that the outlet
drains into a floor drain.
5. Remove the red cap from the steam vent.
6. Remove the red cap from the vacuum break.
7. Make sure that the tubing does not touch the hot surfaces.
Figure 7.
English 13