Clearing Jams - Uline H-2027 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CHECK STAPLE LEG LENGTH
AND ADJUST PLATE POSITION
NOTE: Disconnect the air supply.
APPEARANCE
STAPLE LEG
ANVIL
LENGTH
SIZE
25 mm
25
28 mm
32 mm
32
35 mm
38 mm
38
NOTE: The H-2027 pneumatic carton stapler
is tested before shipping. Please don't move
adjust plate position.
If you want to operate with different leg length
staples, please change to the suitable clincher
and move the adjust plate to suitable position.
CLEANING THE STAPLER
WARNING! Never use gasoline or other
flammable liquids to clean the stapler. Vapors
could ignite by a spark and cause the stapler
to explode, resulting in death or serious
personal injury.
1.
Disconnect the air supply from the stapler.
2. Remove tar buildup with kerosene #2 fuel oil or
diesel fuel. Do not allow solvent to get into the
cylinder or damage may occur.
3. Dry off the stapler completely before use.
PAGE 3 OF 12
OPERATION CONTINUED
ADJUSTING PLATE
THREADING
POSITION
DEPTH
6
15 mm
6
15 mm
5
18 mm
4
18 mm
6
24 mm
MAINTENANCE
OPERATING THE STAPLER
WARNING! Protect your eyes and ears.
Wear safety glasses with side shields. Wear
hearing protection. Employers and users are
responsible for ensuring the user or anyone
near the stapler wears this safety protection.
WARNING! To prevent accidental injuries, never
place a hand or any other body part in staple
clinching area to adjustment window. Never
point stapler at anyone else. Never engage
in horseplay. Always handle the tool with care.
Never pull trigger unless the stapler is ready for
operation.
WARNING! Check and replace any damaged
or worn components on the stapler.
1. Add a few drops of Unocal RX22 or 3-In-1 oil into the
air inlet.
2. Install a quick connect fitting to the stapler.
3. Regulate the air pressure to obtain 85psi.
4. Insert staples. See Loading the Stapler on page 2.
5. Reconnect the air hose to the stapler.
6. Grasp handle with one hand and position on box in
the desired staple location. Pull trigger, then release.

CLEARING JAMS

1.
Disconnect the air supply from the stapler.
2. Pull pusher back and rotate to locked position.
(See Figure 5)
Figure 5
1014 IH-2027

Publicidad

Tabla de contenido
loading

Tabla de contenido