Uline H-2027 Manual De Instrucciones página 4

3. Insert long nose pliers or screwdriver to clear jam.
(See Figure 6)
Figure 6
WARNING! Stop using the stapler immediately if any of the following problems occur. Any repairs or
replacements must be done only by a qualified person or an authorized service center.
OPERATING ISSUE
Air leak from trigger.
Air leak from exhaust port.
Air leak from cylinder.
Excessive jams.
Uneven clinch.
Unclinched staple.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 4 OF 12
MAINTENANCE CONTINUED
4. Slowly release pusher back into position.
TROUBLESHOOTING
CAUSES
O-ring on valve is damaged.
Tube on valve is damaged.
O-ring on valve is damaged.
Tube on valve is damaged.
Piston o-ring is damaged.
Magazine seat o-ring is damaged.
Clincher screws are loose.
Staple size is wrong.
Insufficient lubrication.
Wrong staple size.
Clincher is loose.
Clincher is broken.
1-800-295-5510
uline.com
(See Figure 7)
RECOMMENDATIONS
Replace the o-ring.
Replace the o-ring.
Replace the o-ring.
Tighten screws.
Use the proper size staple.
Clean and lubricate sufficiently.
Check for proper leg length
adjustment and clincher size.
Tighten clincher.
Replace clincher.
Figure 7
1014 IH-2027