Safety Checks - Stiga TITAN 740 DC Instrucciones De Uso

EN
Never use oil additives.
The oil level must never go below the lower mark-
ing. This can cause the engine to overheat. Drain
the oil to the correct level if the oil level exceeds
the mark. See 6.7.
Reinstall the oil filer cap once the oil level has
been adjusted.
5.4 LEVEL CHECK, COOLANT
The temperature indicator will not
work if there is no coolant. This results
in engine failure.
Check the coolant level every time before use to
ensure it is correct.
Check the following:
1. The engine must be cold when checking.
2. Remove the front engine cover. See 3.4.5.2.
3. Unscrew the radiator cap (8:Q) and check that
the coolant level reach the filler hole.
4. Reinstall the radiator cap.
5. Check that the coolant level is at the lower mark
(5:D1) in the expansion tank.
If necessary, top up with coolant. See below.
5.4.1 Topping up with coolant
The coolant must meet the following require-
ments:
• Always use a mixture of refrigerant and water.
Never use just water.
• Mix the water and refrigerant according to the
refrigerant supplier's instructions.
• Never mix different refrigerants.
• Use soft water (no calcium content), distilled or
demineralised water.
The engine must be cold when filling.
If the radiator cap is opened when the
engine is hot there is a risk of serious
burn injuries from hot water that may
spray out.
Top up as follows:
1. Remove the front engine cover.
2. Check that all the plugs in the cooling system
are installed and sealed.
86
All manuals and user guides at all-guides.com
ENGLISH
. Check that all the taps in the cooling system are
4. Check that all the hoses in the cooling system
5. Unscrew the radiator cap (8:Q).
6. Slowly fill the radiator with coolant. Air bub-
7. Reinstall the radiator cap.
8. Open the cap on the expansion tank (5:D) and
9. Close the cap for the expansion tank.
10.Run the engine to operating temperature and
11.If the level is not up to the upper mark, allow the
5.5 AIR FILTER INDICATOR
Check to make sure that the air filter indicator
(5:I10) has not been tripped.
Check, see 3.5.10.
Replace the air filter, see 6.13.
5.6 WATER SEPARATOR
Check that the water separator's float (9:C3) is at
the bottom. If not, the water needs to be drained.
See 6.4.
Check that the water separator's tap is open. See
fig. 9.

5.7 SAFETY CHECKS

Check that the results of the safety checks below
are met when testing the machine.
Original instructions for use
closed and sealed.
are intact and sealed.
bles must not form when filling. Fill up to the
filler hole.
top up the mixture to the lower mark which is
the level when the engine is cold.
check the level in the expansion tank. The level
should now be at the upper mark (5:D2), which
is the level for when the engine is hot.
engine to cool and then top up with coolant in
the expansion tank.
The safety checks must always be
carried out before use.
If any of the results below are not met,
the machine must not be used! Take the
machine to a service workshop for
repair.