GE GXSHC40N Instrucciones De Instalación página 10

Ocultar thumbs Ver también para GXSHC40N:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Requirements
INLET/OUTLET PLUMBING
REQUIREMENTS
Always install either a single bypass valve
(provided),as shown in Figure 4, or, if desired,
parts for a 3 valve bypass system (not
included) can be purchased and assembled, as
shown in Figure 5. Bypass valves allow you to
turn off water to the softener for maintenance if
needed, but still have water in house pipes.
Pipe fittings must be 1/2" minimum.
Use:
Copper pipe
Threaded pipe
PEX (Crosslinked Polyethylene) pipe
CPVC plastic pipe
Other pipe approved for use with potable
water
IMPORTANT: Do not solder with plumbing
attached to installation adaptors and single
bypass valve. Soldering heat will damage the
adaptors and valve.
SINGLE BYPASS VALVE
WARNING
galvanized cold water pipe may be used to
ground electrical outlets in the home. Failure to
maintain this ground path may result in an
electric shock hazard. If the cold water pipe is
used to ground electric outlets, please refer to
Installing the Ground Wire section before
cutting the pipe.
Pull out for "Service"
(Soft water)
Push in for
"Bypass"
Installation
adaptors
Figure 4
A copper or
3-VALVE BYPASS SYSTEM
For soft water service: Open the inlet and
outlet valves and close the bypass valve.
For bypass hard water: Close the inlet and
outlet valves and open the bypass valve.
3 VALVE BYPASS
Outlet
Valve
From Water
Softener
10
Bypass
Valve
To Water
Softener
Figure 5
Inlet
Valve

Publicidad

Tabla de contenido
loading

Tabla de contenido