GE GXSHC40N Instrucciones De Instalación página 13

Installation Instructions
GETTING ACCESS TO MAIN CONTROL BOARD
(TO PLUG IN WATER SHUTOFF VALVE)
INSTALL MOTORIZED WATER
SHUTOFF VALVE
Install the included water shutoff valve on the
threaded installation adapter leading to the
water softener's INLET. Optionally, it may be
installed elsewhere in the plumbing upstream of
the water softener inlet, making sure that the 10
foot long cable will reach the water softener's
main control board (see illustration). The shutoff
valve's inlet and outlet are female 1" NPT.
Support the weight of the shutoff valve.
After completing plumbing, make sure that
the water softener is not powered up, and
plug the cable from the shutoff valve into the
corresponding connector on the main control
board (see illustration at right).
NOTE: The shutoff valve may be operated
manually by pulling out and turning the knob
on the shutoff valve body, although there is no
need to do this when installing.
CAUTION
when it is plugged into the electronic controller.
Do not place fingers into
the motorized shutoff valve
1. Pull out both tabs on back of the top cover
to unlock cover.
2. Tilt top cover upward and lift off.
3. Open salt lid and tilt back until is rests.
4. Pull both tabs toward center to unlock
faceplate.
Salt Lid
5. Tilt faceplate forward to expose back of
the control board.
Faceplate
13
Top Cover
Top Cover
Faceplate