Programming The Softener; Control Operation - GE GXSHC40N Instrucciones De Instalación

Programming the Water Softener
When the transformer is plugged into the
electrical outlet, a model code and test number
(example: y4.1 & H40) are shown in the
display. Then, "12:00 PM" begins to flash. An
arrow is displayed next to CLOCK on the
face plate decal.

CONTROL OPERATION:

• CONTROL SETTINGS REQUIRED upon
initial installation and after an extended power
outage.
• Use the MODE/SET button to scroll arrow to
desired control function set.
• After the mode is selected use the UP
and DOWN buttons to change the
settings of the control.
• Press the MODE/SET button to accept
changes.
• A "beep" sounds while pressing buttons for
control programming. One beep signals a
change in the control display. Repeated
beeps mean the control will not accept a
change from the button you have pressed,
and you should select another button.
SET TIME OF DAY
1. Press MODE/SET button until the arrow
points to CLOCK.
2. Press the UP
to set the present time. UP
display ahead; DOWN
back. Be sure AM and PM is correct.
Salt Level
Clock
Hardness
Recharge
NOTE: Press buttons and quickly release
to slowly advance the display one number
at a time. Hold the buttons down for fast
advance.
3. When the correct time is shown in the
display, press MODE/SET to accept.
18
or DOWN buttons
moves the
sets the time
PM