Replacement Of The Safety High Boot (Pvc) - MSA Vautex Elite ET Trainer Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 69
MAINTENANCE
5.7.

Replacement of the Safety High Boot (PVC)

1
Safety high boot (PVC)
Fig 5
1
High boot complete
2
Protective suit leg
3
Screw and nut clamp
4
Clamp protection
Removal of the Safety High Boot (PVC)
(1) Remove cap tube from the boot shaft.
(2) Open protective suit zip fully.
(3) Turn protective suit legs inside out.
(4) Loosen and remove screw and nut clamp (SW7).
(5) Pull out tube piece.
(6) Remove safety high boot from the protective suit leg.
Fitting of the Safety High Boot (PVC)
(1) Push safety high boot into the suit leg that was turned inside out.
(2) Align suit leg and boot.
(3) Insert tube piece in the boot shaft.
(4) Fit the screw and nut clamp on.
(5) Turn clamp lock towards the rear.
(6) Fit clamp protector under clamp
(7) Tighten screw and nut clamp with SW7, tightening torque: 700 ±30 Ncm.
(8) Clamp protection must cover the clamp lock.
(9) Fit cap tube over shaft of boot.
16
2
3
4
5
7
6
5
Tube piece
6
Safety high boot (PVC)
7
Cap tube (protective rubber) for safety high boot
Vautex Elite ET Trainer
MSA
GB

Publicidad

Tabla de contenido
loading

Tabla de contenido