Use; Safety Regulations; Preparation - MSA Vautex Elite ET Trainer Manual Del Usuario

MSA
3.

Use

3.1.

Safety Regulations

Attention!
Do not use the Protective Suit for Training in case of emergency, it is not chemical
resistent. The Protective Suit for Training is only for training to use the Chemical
Protective Suit Vautex Elite ET.
Attention!
The Vautex Elite ET Trainer protective suit is not suitable for firefighting.
Before donning the suit, the wearer must check that there are no missing parts (e.g. suit valves,
gloves and boots).
When using in the colder environments thermal clothing is recommended.
As clothing under the protective suit the following is recommended:
cotton underwear and socks,
cotton gloves,
e.g.one-piece overall with legs and sleeves that can be closed tightly or a firefighting
protective suit,
protective helmet:
MSA Linesman, MSA Gallet: F1S, F1SA, F1E, F1SF, F2 or F2 X TREM.
3.2.

Preparation

Before donning the protective suit the following instructions must be followed:
(1) Spread the protective suit on the floor.
(2) Align the sleeves and legs of the protective suit ensuring there are no twists.
(3) Open the zip fully and carefully in stages.
(4) Treat the suit lens on the inside and the lens of the respiratory protective mask on the
inside and outside with the anti-misting agent MSA Klar-pilot.
(5) Place the safety high boot (PVC) upright and expose the boot openings.
(6) Align the suspenders if available.
(7) Switch on the radio, adjust and test.
(8) Check the compressed air breathing apparatus and full face mask in accordance with the
corresponding operating manual and check the sealing.
GB
Vautex Elite ET Trainer
USE
7