D.fixed Front Footrests; Backrest; Seat Sling; G.cushion - Quickie M6 Manual De Instrucciones

E N G L I S H

D.FIXED FRONT FOOTRESTS

5
1. Adjustment
a. Remove mounting bolts on the top of each extension tube.
b. Make sure the inserts remain in place.
c. Slide footrest tube into front frame tube to desired height.
d. Line up holes and replace the bolt on the outside through frame, footrest and insert.
e. Follow same procedure on opposite side.
f. Align footrests to desired inward/outward rotational position and tighten firmly.
E. BACKREST
6
1. Height Adjustment
a. Remove the backrest upholstery from the frame.
b. You will see the backrest tube which telescopes into the frame and is secured by a
screw on the side of the frame.
c. There are holes 1 1/8 inch apart from which you may choose to set the back height.
d. Remove the two backrest bolts from the rear frame tubes.
e. After selecting the proper height, insert bolt through frame and backrest tube.
f. Attach upholstery tab to bolt and tighten nut and bolt assembly.
g. Insert nylon tie through upholstery grommets. Tighten and cut off excess nylon tie.
F. SEAT SLING 7
The seat sling can be adjusted through the use of VELCRO® material beneath the seat.
1. Adjustment
a. Remove the screws retaining the left side seat sling.
b. Readjust VELCRO® material to adjust the tension in the seat sling.
c. Replace screws.
d. If there is any difficulty in reattaching the screws, try using a probe to help line up the
holes.
G. CUSHION
1. Installation
a. Place cushion on seat sling with VELCRO® material side down. The beveled edge of the
cushion should be in front.
b. Press firmly into place.

H.REAR AXLES

The most important adjustment on your Quickie wheelchair is the position of the rear axle.
The center of gravity, wheel camber and wheelbase are all determined by the axle adjust-
ment.
Use a torque setting of 115 in.-lbs. when adjusting rear axle.
8
1. Center of Gravity
Moving the center of gravity to the front will lighten the force required to turn the chair. The
further back the axle, the more stable the chair becomes.
The center of gravity is adjusted by moving the rear axle forward or backward on the
indexed axle plate. Moving the axle forward will increase your turning speed and lighten the
front end.
IX. SET-UP, DJUSTMENT ND USE
Plate
13
Axle
Axle
Sleeve
5
6
7
8
930457 Rev. C