Wheel Locks; Anti-Tip Tubes (Optional) - Quickie M6 Manual De Instrucciones

E N G L I S H
2. Wheel Base Width Adjustment
Adjusting the wheelbase width allows the rider the option to move the wheels closer or fur-
ther away from the hips. This gives the proper wheel spacing to maximize pushing efficiency.
a. Loosen the nuts, and reposition the axle sleeve (A) to the desired width.
b. Retighten nuts.
3. Seat Height Adjustment
To adjust the seat height, invert the axle plate and move vertically to align with the appropri-
ate predrilled frame holes. Compare figures 8 and 10. Figure 8 represents the short seat
height. Figure 10 represents the tall seat height. This adjustment allows a 1.5" vertical seat
height adjustment.
NOTE– A new front caster wheel should be used to correspond with any change in seat height.
4. Rear Wheel Axle Adjustment
Tight axle sleeves should be maintained for proper
performance of the wheelchair.
a. To adjust the axle you will need a 5/16" wrench to turn the outside axle nuts.
b. You will also need a 9/16" wrench to lodge the ball bearings, on the opposite end of
the axle, and prevent the axle from turning.
c. Turn the outside axle nut counterclockwise to tighten.
d. There should only be zero to ten thousandths of an inch (.010") of play.
I. WHEEL LOCKS
Quickie M6 wheelchairs are shipped with two wheel locks. Wheel locks are installed at the
factory unless you have requested otherwise.
Use a torque setting of 115 in.-lbs. when setting up wheel locks.
1. Push-to-Lock Wheel Locks Adjustment
a. Using a 3/16" Allen wrench, turn one of the screws in the clamp counterclockwise one-
quarter turn.
b. Repeat the same process with the second of the two screws.
c. Alternately loosen the screws (two turns each) until both screws are removed.
d. To prevent wheel movement when in the locked position, slide clamp toward the rear
wheel until the wheel lock is embedded into the tire.
e. Tighten screws.
J. ANTI-TIP TUBES
Sunrise recommends anti-tip tubes for all wheelchairs.
Use a torque setting of 115 in.-lbs. when setting up the anti-tip tubes.
1. Inserting Anti-Tip Tubes Into Receiver
a. Press the rear anti-tip release pins on the anti-tip tube so that both release pins are
drawn inside.
b. Insert into the anti-tip tube receiver.
c. Turn the anti-tip tube down until release pins are positioned through the receiver
mounting hole.
d. Insert second anti-tip tube the same way.
2. Adjusting Anti-Tip Receiver
a. Remove anti-tip tubes from anti-tip receivers.
b. Remove bolts from anti-tip tube receiver.
c. Reposition bracket to desired height.
d. Reinsert bolts and tighten.
e. Repeat with second anti-tip tube receiver. Both brackets should be at exactly the same
height.
f. Replace anti-tip tubes.
930457 Rev. C
9
10
11
12
(optional)
13
13
IX. SET-UP, DJUSTMENT ND USE
14
9
A
10
11
12
13