Set-Up , Adjustment And Use; To Mount & Remove Rear Wheels; Removable Height-Adjustable Armrests; C.swing-Away Hangers And Footrests - Quickie M6 Manual De Instrucciones

E N G L I S H
NOTE ON TORQUE SETTINGS: A torque setting is the optimum tightening which should be made on
a particular fastener. It is important to use proper torque settings where specified. When not specified,
torque settings should be 60 in.-lbs.
A. TO MOUNT & REMOVE REAR WHEELS
Do not use this chair UNLESS you are sure both quick-release axles are locked.
An unlocked axle may come off during use and cause a fall.
NOTE– Setting the wheelchair on a flat surface, such as a workbench or table, helps make these
procedures easier.
1. To Install Wheel
a. Depress quick-release button (A) fully. This will release tension on ball bearings at other end.
b. Insert axle (B) through hub of rear wheel.
c. Keep button (A) depressed as you slide axle (B) into axle sleeve (C).
d. Release button to lock axle in axle sleeve. Adjust axle if it does not lock.
e. Repeat steps on other side.
NOTE– The axle is not locked until the quick-release button pops out fully (A) and the ball bearings are
fully visible on the outside of the sleeve. Check that the axle is locked by pulling on the wheel in
the direction of the axle.
2. To Remove Wheel
a. Depress quick-release button (A) fully.
b. Remove wheel by sliding axle (B) completely out of axle sleeve (C).
c. Repeat steps on other side.
B. REMOVABLE HEIGHT-ADJUSTABLE ARMRESTS
Height-adjustable armrests are installed at Sunrise.
1. Height Adjustment
a. Release the upper securing lever.
b. Slide armpad up or down to
desired height.
c. Return lever to locked position.
2. Removing Armrest
a. Depress the release latch, and lift the armrest up.
b. To return armrest to operating position, drop armrest into receiver, and pull lever
back. Make sure the armrest is locked in place.
C. SWING-AWAY HANGERS AND FOOTRESTS
(60º, 70º, 70ºV OR 90º)
4
1. Installation
a. Place swing-away pivot saddle into the receiver on front frame tube with the footrest
facing outward from the frame. (D)
b. Rotate the footrest inward until it locks into place on locking bolt. (E)
2. Removal
a. To remove footrest, push release latch toward the frame.
b. Rotate footrest outward and lift.
930457 Rev. C
1
WARNING
12
IX. SET-UP, DJUSTMENT ND USE
2
3
3
Removable Height-Adjustable
Armrest
1. Armrest Pad
2. Upper Securing Lever
3. Release Latch
4. Armrest Panel
5. Rear Receiver
A
B
C
1
2
4
5
D
E
1
2
3
4