Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7.7 Diode Tests
Read the safety guidelines before use. The circuit must
be without power.
Set the switch to
"OL" indicates an overrange.
7.8 Continuity Tests
Read the safety guidelines before use. The circuit must
be without power.
Set the switch to
The instrument beeps when the circuit under test is continuous or
when circuit resistance is less than 40 ohms ± 10 ohms.
7.9 Capacitance Measurements
Read the safety guidelines before use. The circuit must
be without power.
Automatic or manual measurement ranges: 4 nF to 200 µF
(6 ranges).
Set the switch to
"OL" indicates an overrange.
7.10 Frequency and Cyclic Ratio Measurements
Read the safety guidelines before use.
Automatic or manual measurement ranges: 9.999 Hz to 199.9 kHz
(6 ranges).
The frequency measurement function can be activated in two
ways:
A – Press the Hz% key, with the switch set to V or 400 mA, to
measure up to 400 mA, or with the switch position 0.5 V-
600 V
, to measure from 0 to 40 kHz.
AC
B – Set the switch to Hz, to measure from 0 to 200 kHz on 0.5.-
10 V
.
AC
All manuals and user guides at all-guides.com
and press FUNC. once to display
and press FUNC. twice to display
and press FUNC. three times to display
29
.
.
Publicidad
Tabla de contenido
