Cameo ZENIT Z 120 Manual De Usuario página 18

Settings
Display = Display lighting
DMXFail = Operating status with DMX
signal interruption
Dimmer- = Dimmer Curve
Curve
DimResp. = Dimmer response
WhiteBal = White balance
Autolock = automatic locking of the
control elements
FacReset = Reset
Reset = Restart
ENTER
UP/DOWN
18
Backligh On
Backligh Off
Hold
Blackout
Linear
Exp
Log
S-Curve
Led
Halogen
Red, Green, Blue, White
On
Off
ENTER
UP/DOWN
ENTER
/
ENTER
UP/DOWN
ENTER
/
ENTER
UP/DOWN
ENTER
/
ENTER
UP/DOWN
ENTER
/
ENTER
UP/DOWN
UP/DOWN ENTER
/
ENTER
UP/DOWN
ENTER
/
ENTER
ENTER
/
ENTER
UP/DOWN
ENTER
= permanently on
= deactivation after approx. 40 seconds of inactivity
= last command is held
= activates Blackout
= The light intensity increases linearly with the DMX value.
= Adjustment of the light intensity is finer in the lower DMX value
range and coarser in the upper DMX value range.
= Adjustment of the light intensity is coarser in the lower DMX
value range and finer in the upper DMX value range.
= Adjustment of the light intensity is finer in the lower and upper
DMX value ranges and coarser in the middle DMX value range.
= The spotlight responds abruptly to changes in the DMX value.
= The spotlight behaves in a manner similar to that of a halogen
lamp with gentle changes in brightness.
= Individual white balance. Cross-operating mode setting of the 4
RGBW LED groups
= automatic locking of the control elements after 60 seconds of
inactivity. Display shows: "LOCKED"
Unlock: simultaneously press UP and DOWN for about 5 seconds
= automatic locking of the control elements is deactivated
= Reset to factory setting
= restarting the device while resetting the zoom motor
/
ENTER
/
ENTER
/ /
ENTER ENTER
/
ENTER
/ /
UP/DOWN ENTER UP/DOWN ENTER
/
ENTER
/
ENTER
/
ENTER
/
UP/DOWN ENTER