Using Mounting Screws - Allen-Bradley MicroLogix 1500 Instrucciones De Instalación

All manuals and user guides at all-guides.com
To remove your base unit from the DIN rail:
1. Place a flat-blade screwdriver in the DIN rail latch at the bottom of the base
unit.
2. Holding the base unit, pry downward on the latch until the latch locks in the
open position. This releases the base unit from the DIN rail.

Using Mounting Screws

Mount to panel using #8 or M4 screws.
MicroLogix™ 1500 Programmable Controller Base Units
Mounting Template
Publication 1764-IN001A-ML-P
11