Uline SCOUT H-9560 Manual Del Usuario página 17

Weighing Instruments verified at the place of
manufacture bear the following supplementary
metrology marking on the descriptive plate.
MXX 1259
Weighing Instruments to be verified in two stages have
no supplementary metrology marking on the descriptive
plate. The second stage of conformity assessment must
be carried out by the applicable weights and measures
authorities.
If national regulations limit the validity period of the
verification, the user of the weighing instrument must
strictly observe the re-verification period and inform the
weights and measures authorities.
As verification requirements vary by jurisdiction, the
purchaser should contact local weights and measures
office if they are not familiar with the requirements.
FCC COMPLIANCE STATEMENT
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
PAGE 17 OF 53
TECHNICAL DATA CONTINUED
1-800-295-5510
uline.com
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
ISED CANADA COMPLIANCE STATEMENT
This Class B digital apparatus complies with Canadian
ICES-003.
ISO 9001 REGISTRATION
The management system governing the production of
this product is ISO 9001 certified.
1021 IH-9560