Uline SCOUT H-9560 Manual Del Usuario página 2

INTENDED USE
This scale is intended for use in laboratories, schools,
businesses and light industry. It must only be used
for measuring the parameters described in these
instructions. Any other type of use and operation
beyond the limits of technical specifications, without
INSTALLING COMPONENTS
Refer to the illustrations and instructions below to
identify and assemble scale with its components. All
components must be assembled before using the scale.
RELEASING TRANSPORTATION LOCK
Release the red transportation lock by turning the red
pointer 90 degrees counterclockwise to unlock.
(See Figure 1)
Figure 1
Subplatform
INSTALLING THE WEIGHING PAN
For scales with a rectangular pan, place pan into
subplatform and rotate counter clockwise until it locks.
For scales with round a pan, place pan straight down
on subplatform. (See Figure 2)
Figure 2
PAGE 2 OF 53
SAFETY CONTINUED
INSTALLATION
Transportation
Locked
Lock Pointer
Position
Unlocked
Position
written consent, is considered not intended. This scale
complies with current industry standards and the
recognized safety regulations, however, it can constitute
a hazard in use. If the instrument is not used according
to these instructions, the intended protection provided
by the instrument may be impaired.
CAPACITY LABEL
Attach capacity label above the screen. (See Figure 3)
Figure 3
Capacity Label
Zero
Yes
SECURITY SLOT
This is provided at rear of scale, allowing it to be secured
by optional cable and lock accessory. (See Figure 4)
Figure 4
SELECTING LOCATION
For best performance, scale should be used in a clean,
stable environment. Do not use in environments with
excessive drafts, with rapid temperature changes, near
magnetic fields or near equipment that generates
magnetic fields or vibrations.
Print Function Tare
Units Mode Menu
No Back Exit
Security
Slot
1021 IH-9560