Troubleshooting - Uline SCOUT H-9560 Manual Del Usuario

CLEANING
WARNING! Electric shock hazard. Disconnect
the equipment from power supply before
cleaning.
The housing may be cleaned with a cloth dampened
with a mild detergent if necessary.
ATTENTION! Do not use solvents, chemicals,
alcohol, ammonia or abrasives to clean the
housing or control panel.

TROUBLESHOOTING

SYMPTOM
Cannot turn on No power to scale.
Improper calibration.
Poor accuracy
Unstable environment.
Cannot calibrate Security switch in locked position.
Err 8.1 Weight exceeds power on zero range.
Weight below power on zero range.
Err 8.2
Err 8.3 Overload (weight exceeds rated capacity).
Underload (pan removed).
Err 8.4
Err 8.5 Tare out of range.
Displayed value exceeds 999999 (possible
Err 8.6
in Totalization mode).
Unknown internal weight position.
Err 8.7
Parts counting or percentage error –
sample weight <1d. Scale shows error, then
rEF.Err
exits parts counting or goes to [Clr.APU].
Percent Reference weight or APW is too low
Lo.rEF
for accurate results.
Failure to calibrate.
CAL E
Cannot find menu or app file in U-disk.
USb.Err
PAGE 13 OF 53
MAINTENANCE
POSSIBLE CAUSE
SERVICE INFORMATION
If the troubleshooting section does not resolve or
describe problem, contact Uline Customer Service at
1-800-295-5510.
ACCESSORIES
• RS232 kit
• USB Host kit
• USB Device Kit
• Bluetooth Kit
• Ethernet Kit
• Stacking Kit, x6
• Stacking Kit, x1
• Specific Gravity kit
• Auxiliary Display Kit
• Carrying Case
• In-Use Cover
• Printers and Cables
1021 IH-9560