Working With The Machine - Festool CARVEX PSC 420 EB Manual De Instrucciones

Inserting saw blade
WARNING
Risk of injury

Always disconnect the battery pack before per-
forming any type of work on the machine!

If necessary, lift up the chip guard [1-1].

Slide the saw blade [5-4] into the opening [5-2]
as far as the stop with its teeth in the cutting di-
rection.

Turn the saw blade [5-4] clockwise approx. 30°.
Check that the saw blade is secure. A loose
saw blade can fall out and cause an injury.
 If the saw blade is very small, it is advisable to
remove the saw base (see chapter Changing
saw table) before inserting the saw blade.
5
6
5-1
6-1
5-2 6-2
Adjust the saw blade guide after every saw blade
change:
The saw blade guide was designed to improve guid-
CAUTION
Material with high dust generation (e.g. plaster-
board)
Damage to machine through dust penetration,
risk of injury

Do not work overhead!
ance of the saw blade.

Remove the saw base (see chapter Changing
saw table).

Tighten the screw [6-2] using the Allen key [6-1]
until the jaws are almost touching the saw blade.
Damage to the machine or saw blade

Do not tighten the screw [6-2] too firmly! It must
be possible to move the saw blade slightly.
7
6
5-3
6-3
Ejecting saw blade
 When ejecting the saw blade, hold the electric
power tool such that no persons or animals can
be injured.

Push the saw blade ejection [5-3] forwards as
far as the stop.
Saw blade is thrust out mechanically.
5-4
6-4
 A tool change is only possible when the tool
holder is located in the upper position!
If the saw blade is stuck and cannot be changed:
Operate the jigsaw at high speed for 3 - 10 seconds.
Actuate the saw blade ejection [5-3] again.

Working with the machine

NOTE
+
+
-
-
7-1
6-1
7-2
6-2
13