Worx WT525 Manual Del Usuario página 14

Fig 7.1
Fig 7.2
14
Cordless Circular Saw
NA-WT525-M-050727.indd 14
All manuals and user guides at all-guides.com
TERY CHARGER.WHY?
The battery can be inserted into the charger only in one
direction.Turn the battery around until it can be inserted
into the slot, the red LED light should turn on when the
battery is charging (See Fig 7.1, 7.2).
4. REASONS FOR DIFFERENT CHARGING TIMES.
Your charge time can be affected by many reasons -
which are not defects in your product. If the battery pack
is only partly discharged it may be re-charged in less than
1 hour. If the battery pack and ambient temperature are
very cold then re-charging may take 1 to 1 1/2 hours. If
the battery pack is very hot it will not re-charge because
the internal temperature safety cut-out will prevent it. If
hot you must remove your battery pack from the char-
ger and allow your battery pack to cool first to ambient
temperature and then recharging can be started. If you
charge a second battery pack immediately after the first
then the charger can be over-heated. Always allow at
least 15 minutes rest between battery pack charging.
5. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, as above, and having not used
a battery pack for a prolonged time will reduce the bat-
tery pack working time. This can be corrected after sev-
eral charge and discharge cycles by charging & working
with your saw. Do not re-charge your battery pack below
36 F and above 95
O
affect performance.
MAINTAIN TOOLS WITH CARE
Keep tools sharp and clean for better and safer perfor-
mance. Follow instructions for lubricating and changing
accessories. Inspect tool cords periodically and if dam-
aged, have repaired by authorized service facility.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust. If you see some sparks flashing in the ven-
tilation slots, this is normal and will not damage your
power tool.
F (2 C and above 35 C) as this will
O O O
WT525
2005-7-27 17:46:08