Scope Of Delivery; Accessories (To Be Ordered Separately); Environmental Protection; Safety Instructions - Bosch CRR 220 Instrucciones De Funcionamiento

2.

Scope of delivery

R
CRR 220
R
Operating instructions (CD-ROM)
2.1 Accessories (to be ordered
separately)
Designation Function / order number
Voltage stabilizer 1 687 022 873
Adapter CRI/CRIN (K) 0 986 613 506
Adapter CRI/CRIN (AK) 0 986 613 507
Adapter CRIN (Terminal) 0 986 613 508
Instructions for using the voltage stabiliser:
Replace the enclosed power line with an IEC
plug, if necessary, with a power line with a
country-specific mains plug
(100-230 V/ 13A). Never use AC adapters,
such as travel adapters!
¶
Do not overload the mains supply circuit
and the mains socket, if in doubt, contact
an electrician.
Fig. 1: CRI/CRIN Adapter (K) - 0 986 613 506
Fig. 2: CRI/CRIN Adapter (AK) - 0 986 613 507
Fig. 3: CRIN Adapter (terminals) - 0 986 613 508
Robert Bosch GmbH
Scope of delivery | CRR 220 | 9
3.

Environmental protection

Please take the packaging for recycling to the appropri-
ate collection points. In countries other than Germany,
please consult the appropriate local regulations.
4.

Safety instructions

!
The following safety instructions do not claim to
be exhaustive and only relate to work performed
directly on the components.
!
Observe the applicable accident prevention regu-
lations. It is assumed that personnel who work
on the system will be suitably qualified and that
they carry out the work conscientiously and in the
proper manner!
!
Make sure that systems and devices are only used
for their intended purpose.
!
Shut off the power before disconnecting / connect-
ing wires or connectors. Avoid sparks!
!
Only operate the CRR 220 with suitable voltage
stabiliser 24V DC/ ≥ 20A.
!
The voltage stabiliser's earth wire (PE) must be
connected.
!
The 24 V (-) connection must be connected to the
protective earth conductor (PE); refer to Chapter 5
(Electrical Connection).
!
Please observe the correct polarity when connect-
ing the CRR 220; the device should never be used
with the polarity reversed.
!
Never operate the CRR 220 with worn or defective
accessories.
!
Degree of protection IP 20: Only use the device in
the prescribed testing room.
en
|
0 986 629 504 2014-02-18