Audio Setup - Sound Settings; Video Setup - Image Settings - Blaupunkt 7 607 276 016 Instrucciones De Manejo

DVD SETUP
Normal/PS: The DVD player is
connected to a 4:3 monitor. The
wide image is displayed using the
full height of the screen. The left
and right edge of the wide image
is automatically cut off.
Wide: The DVD player is con-
nected to a 16:9 monitor. The wide
image is displayed on the screen at
full size.
Note:
The following functions in the Gen-
eral Setup are not supported by the
CVX 02 and cannot be changed:
• Angle Mark
• Captions
• Priority
Please do not attempt to change
these settings.

Audio Setup - Sound settings

In the Audio Setup, you can adjust
Dynamic Range Control (DRC).
Dolby Digital Setup -
Dynamic Range Control
The setting of DRC is located under
"Dynamic" in the "Dolby Digital Setup".
Dynamic Range Control means that the
difference between "loud" and "soft"
sounds is adjusted. The volume of soft
sounds is increased and that of loud
sounds is lowered. You can use the
DRC of the device to set the dynamics
of a Dolby programme in increments
from "OFF" to "Full". Select the "FULL"
setting for full dynamic adjustment.
38
Note:
The following functions in the Video
Setup are not supported by the
CVX 02 and cannot be changed:
• SPDIF Output
• PCM Channel
• LPCM OUT
• HDCD
Please do not attempt to change
these settings.

Video Setup - image settings

In the Video Setup, you can perform dif-
ferent settings for an optimal image play-
back on the connected monitor.
Adjusting picture sharpness
The setting for picture sharpness is lo-
cated in "Quality" under "Sharpness".
To adjust the picture sharpness, you can
select among the settings "High", "Me-
dium" and "Low".
Brightness
The setting for brightness is located in
"Quality" under "Brightness".
You can adjust the brightness in incre-
ments from -20 to +20.
Contrast
The setting for contrast is located in
"Quality" under "Contrast".
You can adjust the contrast in incre-
ments from -16 to +16.