Endress+Hauser Proservo NMS81 Manual De Instrucciones página 216

Menú de configuración
Probe position
Navegación
Requisito previo
Descripción
Entrada de usuario
Información adicional
Damping factor
Navegación
Requisito previo
Descripción
Entrada de usuario
Información adicional
Gauge current
Navegación
Requisito previo
Descripción
Información adicional
216
 Setup → Advanced setup → Input/output → Analog IP → Probe position
Operating mode (→  212) = RTD temperature input
Position of the temperature probe, measured from zero position (tank bottom or datum
plate). This parameter, in conjunction with the measured level, determines whether the
temperature probe is still covered by the product. If this is no longer the case, the status of
the temperature value will be ' i nvalid' .
–5 000 ... 30 000 mm
Acceso de lectura
Acceso de escritura
 Setup → Advanced setup → Input/output → Analog IP → Damping factor
Operating mode (→  212) ≠ Disabled
Defines the damping constant (in seconds).
0 ... 999,9 s
Acceso de lectura
Acceso de escritura
 Setup → Advanced setup → Input/output → Analog IP → Gauge current
Operating mode (→  212) = Gauge power supply
Shows the current on the power supply line for the connected device.
Acceso de lectura
Acceso de escritura
Operator
Maintenance
Operator
Maintenance
Operator
-
Proservo NMS81


Endress+Hauser