DeWalt DCG414 Manual De Instrucciones página 19

4.5" (115 mm) and 6" (150mm) grinding Wheels
Type 27 guard
unthreaded backing flange
Type 27
depressed center wheel
threaded locking flange
4.5" (115 mm)and 6" (150mm) Cutting Wheels
Type 1/41 guard*
unthreaded backing flange
Type 27/42 depressed
center wheel, cutting only
threaded locking flange

Type 1/41 guards are intended for use with Type 1/41 cutting wheels and Type 27 wheels marked for cutting only.
Grinding with wheels other than Type 27 and Type 29 require different accessory guards. Always use the smallest proper
guard possible that does not contact the accessory.
* nOTE: A Type 1/41 guard is available at extra cost from your local dealer or authorized service center.
ACCESSORIES CHART
Type 27 guard
Type 27 hubbed wheel
4.5" (115 mm) and 6" (150mm) sanding Flap Discs
Type 27 guard
unthreaded backing flange
non-hubbed sanding flap disc
threaded locking flange
Type 1/41 guard*
unthreaded backing flange
Type 1/41 abrasive cutting
wheel
threaded locking flange
Wire Wheels
Type 27 guard
3 - 5" * (76.2 - 127 mm)
wire cup brush
Type 27 guard
hubbed sanding flap disc
Type 1/41 guard*
unthreaded backing flange
diamond cutting wheel
threaded locking flange
English
Type 27 guard
4"-6" (100-150 mm) wire
wheel
sanding Discs
rubber backing pad
sanding disc
clamp nut
17