Installing And Removing The Battery Pack - DeWalt DCG414 Manual De Instrucciones

Mounting Wire Cup Brushes and
Wire Wheels

CAUTION: To reduce the risk of personal injury,
wear work gloves when handling wire brushes
and wheels. They can become sharp.

CAUTION: To reduce the risk of damage to the
tool, wheel or brush must not touch guard when
mounted or while in use. Undetectable damage
could occur to the accessory, causing wires to
fragment from accessory wheel or cup.
Wire cup brushes or wire wheels screw directly on the
grinder spindle without the use of flanges. Use only wire
brushes or wheels provided with a 5/8"-11 threaded hub.
A Type 27 guard is required when using wire brushes
and wheels.
1. Thread the wheel on the spindle by hand.
2. Depress spindle lock button and use a wrench on the
hub of the wire wheel or brush to tighten the wheel.
3. To remove the wheel, reverse the above procedure.
NOTICE: To reduce the risk of damage to the tool, properly
seat the wheel hub before turning the tool on.
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.

Installing and Removing the Battery Pack

(Fig. K)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
11
battery pack with the rails inside the tool's handle and slide
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button and firmly pull the battery pack out of the tool
12
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. K
11
Proper Hand Position (Fig. L)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
into the tool handle, align the
12

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main handle
and one hand on the side handle.
Fig. L
Trigger Switch and Lock-off Lever (Fig. M)

WARNING: Before using the tool, check that the side
handle is tightened securely.

WARNING: Hold the side handle and main handle of
the tool firmly to maintain control of the tool at start
up and during use and until the wheel or accessory
stops rotating. Make sure the wheel has come to a
complete stop be fore laying the tool down.
1. To turn the tool on, push the lock-off lever
the back of the tool, then depress the trigger switch
The tool will run while the switch is depressed.
2. Turn the tool off by releasing the releasing switch.

WARNING: Allow the tool to reach full speed before
touching tool to the work surface. Lift the tool from
the work surface before turning the tool off.
Fig. M
nOTE: This tool has no provision to lock the switch in
the ON position, and should never be locked ON by any
other means.
Spindle Lock Button (Fig. N)
The spindle lock button is provided to prevent the
4
spindle from rotating when installing or removing wheels.
Operate the spindle lock button only when the tool is
turned off, the tool is unplugged, and the wheel has come
to a complete stop.
NOTICE: To reduce the risk of damage to the tool, do not
engage the spindle lock button while the tool is operating.
Damage to the tool will result and attached accessory may
spin off possibly resulting in injury.
To engage the lock, depress the spindle lock button
rotate the spindle until you are unable to rotate the spindle
further.
English
2 toward
.
1
1
2
3 and
13