Mounting the adapter for external
extraction
♦
Push the dust extraction adapter
extraction nozzle
♦
Connect an approved dust extraction system.
NOTE
►
When sawing wood or other materials that
can create dusts that are hazardous to
health, always connect a suitable, certified
vacuum extractor appliance.
Adjusting the additional handle
The angle of the additional handle
adjusted to achieve a more favourable working
position for the guide hand in certain applications
(e.g. when grinding close to an edge).
♦
Loosen the two wing screws
additional handle
position.
♦
Retighten the wing screws
Working procedures
WARNING! RISK OF INJURY!
►
Always remove the plug from the power
socket before working on the appliance.
►
Wait until the appliance has come to a
standstill before putting it down.
The removal rate and the surface quality are deter-
mined by the selection of the sanding tool, the
preselected speed level and the contact pressure.
Only sanding tools that are in perfect condition
provide a good sanding performance and protect
the appliance.
■
10
│
GB │ IE
onto the
.
can be
and tilt the
to the desired working
.
Sanding
■
Hold the appliance firmly with both hands
when working and ensure that you have
secure footing.The appliance is guided more
safely with two hands.
♦
Connect your extraction system (internal or
external extraction).
♦
For external suction:
If possible, work with the remote switch-off or
the automatic start/stop function of the vacuum
cleaner. The vacuum cleaner switches on auto-
matically and switches off again after a time
delay in order to remove the remaining dust
from the suction hose.
♦
Switch on the appliance, place it with the entire
sanding surface on the surface you are working
on and move it over the workpiece with
moderate pressure.
♦
To prolong the service life of the accessory tool,
ensure that you apply even pressure.
♦
Use of excessive pressure does not lead to a
greater removal rate, but rather to increased
wear of the accessory tool.
♦
Lift the appliance off the working surface.
♦
For internal extraction:
Let the power tool run for a few more seconds
to remove the remaining dust from the suction
hose
.
PWBS 180 B3